
3
ABOUT THE DEVELOPMENT BOARD
Development board SO-DIMM connector, P15
Pin
10
11
12
13
14
15
Signal
GND (SYNC_RETURN)
NC (Monitor ID0)
NC
HSYNC
VSYNC
NC
Comment
Monitor ID0 is not implemented on the
development board
External LCD
clock, G1
An external LCD controller clock is provided to avoid picture quality deterioration
due to the low-emission spread spectrum clock used on the module.
..................................................................................
G1 is a 48MHz oscillator that supports resolutions up to 640 x 480. The maximum
NS9360 external LCD clock frequency is 90MHz. The frequency is divided by 2 before
being used as the LCD clock source. For more information, see
"SampleDevelopment board SO-DIMM connector, P15
Manufacturer part number: AMP INCORPORATED 390112-1
P15 is a 144-pin SO-DIMM connector on the development board. Plug the
ConnectCore 9C/Wi-9C module SO-DIMM connector, P3, into P15.
Note:
The clearance between the module and your development board must be
2.54mm (0.10”).
40
ConnectCore 9C/Wi -9C Hardware Reference, Rev D 05/2010